With Björn Kroner-Salié
What you need:
(1)
Cut veneer sheets into strips 5 to 8 cm wide. Apply a piece of double-sided adhesive tape to the upper end of the strip.
(2)
Roll up the napkin and wrap the strip centrally around the roll. Remove the protective film from the adhesive tape and glue the ends of the strips together.
TIP
The napkin rings can also be used as a name tag. The effect and suitability of the pen should be tested beforehand on a test piece.
(1)
Cut the amount of foam from the brick, adjusting the size to the vessel. Fill the vessel with water, place pieces of foam on the water surface - do not press under water - and soak. Cut the foam so that it remains approx. 1 cm below the edge of the vessel.
(2)
Lightly cover the foam with the sand. Coat only a little, otherwise the cut surfaces of the flowers will be blocked by the sand.
(3)
Cut the flowers diagonally with a knife or scissors and carefully insert into the foam as desired.
TIP
Always pay attention to the outer edge of the vessel. With such arrangements it is nice when the floristry takes place inside and does not protrude beyond the edge of the vessel.